ATV Drag Racer Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
1,345 Posts
Talk to John at Racers Edge in Tucson AZ, they install Carrillo Rods on all of there cranks and have them balanced with no issues. I had a Carrillo Rod on my 730 Raptor for years and never had a problem with it.
 

·
Premium Member
Joined
·
1,953 Posts
I too heard the honda rod is strong but 70-75 hp is close to the case breaking point.BDHN would know I'm sure.



A friends YFZ 450 motor never had rod issues on spray after he went to a falicon rod. Before that he went thru a couple stockers that took out cases cranks etc.
 

·
Registered
Joined
·
12 Posts
i dont have experience with nitrous induced case failure. i did however, have some detonation caused case failure. it was the left side case right under the steel race. i would think that it would break similarly. hope that helps
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top