ATV Drag Racer Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
im building a nice duner and plan on running a 4mill crank. i just dont know what to get a 4mill with longer rods and a spacer or a 4mill 110 rods and no spacer.i have to get pistons either way
so that doesnt matter
thanks kevin
 

·
Registered
Joined
·
120 Posts
The spacer is typically required for the stroker set-up, not for the choice of rod length as there are long rod pistons available in nominal bore sizes.

Plates are for eating dinner on. Have the cylinders set-up to run without the spacer by altering the porting and custom domes or head to account for the stroke.
 

·
Registered
Joined
·
767 Posts
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top