ATV Drag Racer Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
1,030 Posts
QUOTE (dajogejr @ Aug 18 2009, 09:37 AM) index.php?act=findpost&pid=53540I've tried to find a picture on the Internet to no avail. The clymers manual has it.
The shift shaft as it passes through the whole motor, the clutch side of it has what looks like two "hangers" that are spring loaded.
That's the best I can describe it....

Yep, the hangers are in somewhat of a C-shape around the shift star.
 

·
Registered
Joined
·
767 Posts
Here it is

adjuster bolt

It is #4 on the microfish. It's the offset screw to adjust the shift shaft position.
 

·
Premium Member
Joined
·
1,953 Posts
Ya it adjusts the "C" or arrow shaped part that hits the pins on the shift star. Mine was off a bit when I put mine in and I had to adjust it otherwise mine tried to go in 6th gear which is gone. I had a neutral top and bottom.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top