ATV Drag Racer Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,022 Posts
Discussion Starter #1
You can barely tell in the pic but i don't think it will matter just getting everybodies opinion. Are the screws suppose to stick pass the hub a little after the back plate is mounted? I'm sure i can grind them down a little if there to long.

 

·
Premium Member
Joined
·
2,469 Posts
I dont think you want them sticking threw or it will rub on clutch hub and tear the back side up.
 

·
Registered
Joined
·
1,022 Posts
Discussion Starter #3
Well what i did was eintall the drive gear to the basket installed it and set the inner hub on and it clears the screws. There is a little lip on the inner hub that gives it some clearance but i still think i'm gonna grind em' down a little bit for safe measures. I was just hoping someone else on here has a boss basket and see if there's does the same thing.
 

·
Premium Member
Joined
·
2,469 Posts
I have a billet one on the shelf @ home but i dont have a gear for it to put on it and see.
 
1 - 6 of 6 Posts
Top