Carb Boring
1 - 7 of 7 Posts
Joined
·
699 Posts
QUOTE (dajogejr @ Jul 17 2008, 10:58 AM) index.php?act=findpost&pid=5653I think I know the answer, but want to double check...
35PWKs can be bored to 39 or 40mm, correct? They all use the same body?
If I am not mistaken, no, they cannot be bored that much. I have a friend that had his carbs bored recently, they were 35's, and could only be bored to 37.
35PWKs can be bored to 39 or 40mm, correct? They all use the same body?
If I am not mistaken, no, they cannot be bored that much. I have a friend that had his carbs bored recently, they were 35's, and could only be bored to 37.
Joined
·
120 Posts
37 is safe. Otherwise it leaks past the slide causing idle issues
Joined
·
125 Posts
QUOTE (dajogejr @ Jul 17 2008, 10:58 AM) index.php?act=findpost&pid=5653I think I know the answer, but want to double check...
35PWKs can be bored to 39 or 40mm, correct? They all use the same body?
the 36 pwk can be took out to 39 , it is on the bigger body and slide, one thing is the bore is off center so you have to indicate it from the out side and center the bore.
35PWKs can be bored to 39 or 40mm, correct? They all use the same body?
the 36 pwk can be took out to 39 , it is on the bigger body and slide, one thing is the bore is off center so you have to indicate it from the out side and center the bore.
Joined
·
125 Posts
QUOTE (okbeast @ Jul 18 2008, 02:32 PM) index.php?act=findpost&pid=5775The 36 or the 35?
Who does carb boring?
the 35 pwk can only go to 37
the 36 is the same body and slide as the 39
Who does carb boring?
the 35 pwk can only go to 37
the 36 is the same body and slide as the 39
Joined
·
288 Posts
QUOTE (dajogejr @ Jul 17 2008, 10:58 AM) index.php?act=findpost&pid=5653I think I know the answer, but want to double check...
35PWKs can be bored to 39 or 40mm, correct? They all use the same body?
heres what i noticed. a general rule is they will go about 2mm. but because the manufactiring/machining process from keihin, none of the carbs are exactly the same. some carbs may go 2.5mm, others may only go 2mm...best way is take alittle at a time so you dont go too far
35PWKs can be bored to 39 or 40mm, correct? They all use the same body?
heres what i noticed. a general rule is they will go about 2mm. but because the manufactiring/machining process from keihin, none of the carbs are exactly the same. some carbs may go 2.5mm, others may only go 2mm...best way is take alittle at a time so you dont go too far
1 - 7 of 7 Posts
Join the discussion
Join now to ask and comment!