[okbeast]

Got the clutch all back together and adjusted properly and realized i didn't grease the pancake bearing or the ball/pushrod so i took it all back apart to do that. The ball came right out with a magnet but the pushrod is a different story. It is not welded to the clutch actuator arm because I can spin the pushrod with the magnet (fairly freely) and the pushrod has 1/8" to 1/4" horizontal movement. Is the pushrod suppose to come out with the inner hub and basket/gear all still on? Or do I not have anything to worry about? Gracias

 

[roach]

You should be able to just remove the pressure plate, the ball an rod should slide out. If the rod won't come out, try to remove the clutch arm, use a flash light an look down in the whole and see if the end of the shaft is mushroomed.