ATV Drag Racer Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter · #1 ·
I have a 2006 raptor 700, dual barkers, pc3, web cam, je piston, it runs good from the line but when it gets to mid rpm it cuts out bad then picks back up, it does it in every gear. Any ideas whats happening?? Oh yeah it has a brand new clutch
 

·
Registered
Joined
·
603 Posts
QUOTE (BlznOkie @ Mar 13 2009, 04:06 PM) index.php?act=findpost&pid=34436I have a 2006 raptor 700, dual barkers, pc3, web cam, je piston, it runs good from the line but when it gets to mid rpm it cuts out bad then picks back up, it does it in every gear. Any ideas whats happening?? Oh yeah it has a brand new clutch
Check the tps first. If it does it in every gear at about the same spot the tps may have a glitch in it at mid throttle. Also you may try and unhook the pcIII and see if that helps. You will not want to ride it any longer than it takes to see if the problem is gone as it will be very lean when the pcIII is unhooked.
 

·
Registered
Joined
·
101 Posts
NO NO NO!!!!!!Check your reverse indicator wiring. It has an intermittent connection that under load will indicate that the thing is in reverse and turns on the rev limiter. ride it and watch real close and see if the reverse light flickers, if it does that is your problem.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top