[kevsws6]

Fresh off the Dyno. Dune port on gas with Shearer small bore inframes.

 

[dajogejr]

Hey Kev...it would help if you actually put something on the post....LOL...

 

[kevsws6]

I did it!

 

[dajogejr]

Get some pipes on that bad boy...let it breathe...LOL.
Bet that's a fun ride!!

 

[Boston Racing]

QUOTE (dajogejr @ Sep 16 2008, 07:01 PM) index.php?act=findpost&pid=10916Get some pipes on that bad boy...let it breathe...LOL.
Bet that's a fun ride!!


Awesome, 100 is so much better than 99.9. Good job on the triple digits. Especially on gas.

 

[okbeast]

Very nice, I figured the PV would make more torque?

 

[dajogejr]

The powervalve isn't going to give you "more" torque...it will just give you more consistent torque across a larger range of RPM...which, is clear that it did.
I bet that comes on pretty hard early and revs out well..

 

[WINDYCITYJOHN400]

My 472 4mill made 92HP and 47lbs tq with trinity port work and they're in frames. So your doing great with that setup. Congrats.

 

[kevsws6]

QUOTE (WINDYCITYJOHN400 @ Sep 17 2008, 07:20 PM) index.php?act=findpost&pid=11010

My 472 4mill made 92HP and 47lbs tq with trinity port work and they're in frames. So your doing great with that setup. Congrats.

I think this one was at 89 from Trinity when I got a hold of it.

 

[WINDYCITYJOHN400]

Other than pipes what did you do to it?

 

[kevsws6]

QUOTE (WINDYCITYJOHN400 @ Sep 18 2008, 09:56 PM) index.php?act=findpost&pid=11090Other than pipes what did you do to it?

I went in and ported it more and also raised the compression from 12:1 to 15.5:1

 

[WINDYCITYJOHN400]

Do you know how much PSI you have on a compression check?

 

[kevsws6]

QUOTE (WINDYCITYJOHN400 @ Sep 19 2008, 08:34 PM) index.php?act=findpost&pid=11143Do you know how much PSI you have on a compression check?

I don't know off hand. Squish is .040, a 12.5 degree angle, 24cc fpv, 11mm band width.

 

[camatv]

those pv motors pull o so nicely.. nice curve