ATV Drag Racer Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
Hey guys


How much pressure can be put into marvins ? and would any normal atv shock repair shop would have enough pressure to fill these they need to be pretty stiff because i have a pipes hitting chain problem on my crankenstein.... I'm in canada and marvin shaw is far from here lol...
 

·
Registered
Joined
·
262 Posts
if i recall correctly you can go well over 800 on them. i cant remember exactly what the guy at yarnell told me but its over 1000 i think.

The fitting on them are a standard shock fitting for quads, as long as they carry nitrogen and can fill most afermarket shocks they will be good. you will be suprised how fast you cn loose the pressure, it doesnt take much to get to 600 psi
 

·
Premium Member
Joined
·
354 Posts
You may also find a local welding supply company that can fill them with nitrogen. The big issue will be finding some one with a regulator that will go high enough. My rear comp shaw on my lightened stock frame with a +8 swinger was set at 1100psi. Shaw told me I could go up to 1500psi. Call them they will tell you what you need to know for sure.
 

·
Registered
Joined
·
1,276 Posts
QUOTE (dunejumper @ Jun 18 2008, 01:32 PM) index.php?act=findpost&pid=3096You may also find a local welding supply company that can fill them with nitrogen. The big issue will be finding some one with a regulator that will go high enough. My rear comp shaw on my lightened stock frame with a +8 swinger was set at 1100psi. Shaw told me I could go up to 1500psi. Call them they will tell you what you need to know for sure.
pressure depends on weight and length of the swinger give them a call tell them your set up and youll be right on
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top