ATV Drag Racer Forums banner

Milled Stock Head

907 Views 0 Replies 1 Participant Last post by  spankytat2u
I was looking at ebay and they have a milled stock head that will be milled to meet you bore diameter. My question is if the milling and the bore don't match could this affect my performance?
Motor bored 0.80 and the head is supposed to be milled 0.30 in my case.
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.