ATV Drag Racer Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
Well the a-arms i have have 7/16 heims in them.... The spindles i had made are 1/2 threaded in.(my fault) Ive looked for a heim that is 7/16 to 1/2 hole and no luck no where. I need some advice because come to find out they dont even make aftermarket 7/16 spindles because there border line on being to "unsafe".

So what im thinking is either buying 1/2 heimes and have them machines and treaded for 7/16 or going to stock spindles, but then can i get a 5/8 spindle for that oneor would i have to get new bearings for my spindle mounts?

Here are some pictures so you get a better idea what i am talking about....Any help or advice would be greatly appreciated.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top