ATV Drag Racer Forums banner
1 - 20 of 58 Posts

·
Registered
Joined
·
1,003,688 Posts
wow..thats awesome !!! cant wait to see ur dyno numbers !! keep up the good work !!

i hope u work part time.. because i see u gettin alot of cylns headed ur way..

p.s. have u tried to port any cubs yet ? if so ,hollar at me.


u guys are azz's
 

·
Registered
Joined
·
507 Posts
that would be freakin hilarious if that thing ran hard [censored] hell. I think my one year old might have ported those!
 

·
Registered
Joined
·
1,363 Posts
Instead of sand paper... Why dont you just add some epoxy.... Then you will be ready for buisness... Should run good...... Make sure you port the sleeve to match..
 

·
Premium Member
Joined
·
1,953 Posts
Be sure to "whiffle port" the piston. It'll rev much faster with about 40 holes drilled in the crown of it less resistance going up and down.
 

·
Registered
Joined
·
1,345 Posts
Hum, it seems like you have a few more years of practice to go. Just remember everything follows the least path of resistance! Also bigger it not always better....
 
1 - 20 of 58 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top