ATV Drag Racer Forums banner
1 - 6 of 6 Posts

· Premium Member
2,772 Posts
Discussion Starter · #1 ·
So just got some brand new, Stock Lectron plastic bowls...
416 was nice enough to include the barbs for the PJs.

Question, drilled it about 1/32 smaller than the barb, it threaded in the plastic nicely...very tight fit.

Do you guys use any kind of epoxy or sealer on these?? or just snug fit, the bowl seals around the barb??
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.