Purge Mixture

8533 Views 50 Replies 14 Participants Last post by 06banshee, Jun 10, 2008

dajogejr

Discussion Starter · May 30, 2008

Anyone tried Klotz uplon for purge mix for the meth bikes?

Uplon is the upper end lube that the 4 strokers sometimes use for methanol...it cleans the corrosive meth out of the bikes.

I know Tedders uses it, anyone else?

http://www.klotzlube.com/storeProdDetails.asp?pi=20

Save

1 - 4 of 51 Posts

shovelhead

· #9 · May 30, 2008

so what is best , or reccommended ratio to use in purge? if I am using castor 927? 20:1??

Save

shovelhead

· #11 · May 30, 2008

QUOTE (dajogejr @ May 30 2008, 03:21 PM) index.php?act=findpost&pid=1479The main reason I purge with a lot of oil is to coat the crank bearings....I use 20:1. I think the right ratio is going to be just like anything else, your own personal preference...

I used to use the 20:1 in my chainsaw and weedeater, it was just too much oil...

Too bad...it was "kinda" like being at the track without being there....

LOL

dave you ain't right...LOL

See less See more

Save

shovelhead

· #13 · May 30, 2008

QUOTE (06banshee @ May 30 2008, 06:34 PM) index.php?act=findpost&pid=1497Dave moore doesnt purge.But I dont think its that big of a hassle to purge so I just do it and my builder says to purge so I do.

I just switched to the supertechinplate stuff.Used to run benol.But I purge at 32:1.Is it just me or does this stuff give you headaches?I got the worst headache from smelling it.

seems a lot of you are going with supertechinplate?? maybe I need to look into doing that myself..?

Save

shovelhead

· #18 · Jun 1, 2008

can you use 927 in both alky & purge?

Save

1 - 4 of 51 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month