I have some spindle mounts, 10/2 that I'm having trouble finding bearings for, I got the wheels off a raptor with stock taper spindles, I'm trying to put them on straight 5/8" spindles. Anyone know where I can find bearings? Or has anyone done this before? Sandtoys is telling me its a different wheel altogether for the 5/8" spindles
If they are made for metric bearings, you will either have to cut the wheels to accept standard bearing sizes or, cut a sleeve to slide over the 5/8" shaft so a metric bearing will fit like its supposed to. I got a hold of some yfz wheels that were that way. I went the sleeve route. Would have been cheaper to sell them and buy some 5/8".
Ya I wanna go the sleeve route, a couple buddies have the sleeves I need, but I can't find out where to get them. I'm dead in the water here, I know someone sells them, here's a picture
Well it pays to know a good machinist, he hooked me up good here,
Sent from my Desire HD using Tapatalk 2
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
ATV Drag Racer Forums
81.4K posts
5.5K members
Since 2008
A forum community dedicated to ATV owners and drag race enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!