ATV Drag Racer Forums banner
1 - 13 of 13 Posts

· Registered
Joined
·
535 Posts
Discussion Starter · #1 ·
ok so i went to atoka over the weekend and put the raptor to the test its a 07 700raptor with a roon woods single exhaust, PCIII, pro design intake and K&N, direct drive lockup, 8over swingarm, 13in mavinshaw's all around, 14pd sls extremes, reg buff smoothies, and a big shot of NOS. still got has everything stock on it exsept heal gards, and parking brake

ended up running a 4.47, need a wheelie bar now though!

but i don't think thats bad on a stock motor the motor has never been apart and i drove that thing outa there no problems rode it all day yesterday too!

just wondering if anyone else has took a stock 700 motor that fast yet?
 

· Registered
Joined
·
535 Posts
Discussion Starter · #9 ·
QUOTE (okbeast @ Jul 15 2008, 01:21 PM) index.php?act=findpost&pid=5395holy reaction time batman lol. cut that down just a little and you'd have a competitive bike as long as it stayed consistent

lol i know it going from a pro 1 light to the other messes me all up! lol but i never have been good at cutting a light anyway kinda new at this track stuff that was the only the third time for me to run on a track!
 

· Registered
Joined
·
795 Posts
QUOTE (SANDPLAYAZ @ Jul 15 2008, 01:50 PM) index.php?act=findpost&pid=5402lol i know it going from a pro 1 light to the other messes me all up! lol but i never have been good at cutting a light anyway kinda new at this track stuff that was the only the third time for me to run on a track!

yeah, last weekend was the 1st time i'd been and my 1st few were pretty bad, but by the end of the night after 4-5 runs i got the hang of it.

what're the plans for the raptor, gonna keep sprayin it with this much or was that just a test to see what it'd run/if it'd hold?
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top