ATV Drag Racer Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I've got some bb drag ported cylinders I was running last year. To make a long story short, I've got a 4mil long rod crank now and custom spacer plate from Nate McCoy. I was wondering if you can get longer dowel pins for the cylinders. With gaskets and spacer plate, the dowel pins are pretty much completely swallowed so that's a bit of an issue. Any info would be appreciated. Thanks.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top