ATV Drag Racer Forums banner

1 - 13 of 13 Posts

·
Registered
Joined
·
208 Posts
looks really nice.
what exactically is that used for and where does it mount on the bike?
 

·
Registered
Joined
·
507 Posts
that repace the lower motor mounts right? I saw a setup like this yesterday. they had a tab welded to the frame where one side bolted up and the other side bolted to the bottom of the cases like the old motor mounts.
 

·
Registered
Joined
·
1,061 Posts
Ive also seen them mounted from the frame to the stator cover to reduce engine twist on the bigger engines
 

·
Registered
Joined
·
1,022 Posts
Discussion Starter #8
Thanks yall it was ugly as hell before it went to the chromer.

Dave do me a favor and take a closeup of where you drilled on the stator? It's not in the case itself is it? Just goes on the stator right?
 

·
Registered
Joined
·
153 Posts
Bling Bling LOL. I am really wanting to find another Shee to build a drag bike out of. Mine runs good but I want a nasty ridgid.
 

·
Registered
Joined
·
1,022 Posts
Discussion Starter #11
QUOTE (dajogejr @ Aug 6 2008, 08:28 AM) index.php?act=findpost&pid=7591Mine actually drilled to the stator cover itself. I don't have enough case material to mount it there.

Since yours broke off and was rewelded...well, that's your call if you want to put it there....
WIll get pics later.


Are you talking about mounting it and using the top right stator cover mount to screw it in that way? I was looking at the cases there's not enough material to drill through so was thinking of just doin what you did and use the stator.
 
1 - 13 of 13 Posts
Top