[bada450r]

ok i have a 10 mil twister that i just recently build.......i run 39 makunis tm.....my jetting right now is i have 116 jets and dump tubes also run the big power jets .86 with the needle set at its fattest position.......i'am at sealevel.......the thing is that my old cub used to run 118 with the needle in the middle clip and also the big power jets.......i just dont want to hurt the motor so anyone with jetting experience on the twisters can you plizzzzzzzzz post your findings........thanks.

 

[SoCalinIt]

Not a lot of people on here, but I'm sure this could be a good site. Thanks for letting me know Pablo!

 

[dunedog805]

Hey Bada 450 you might have better luck posting your Question in the 2 stoke tech fourm!

 

[sleeperb]

The 4mill Mini I built had the same jetting in it my buddies 16mm Cheetah had and ran like a champ. So I'm gonna say it will need more fuel.

 

[bada450r]

QUOTE (dunedog @ Jun 17 2008, 03:18 PM) index.php?act=findpost&pid=3026Hey Bada 450 you might have better luck posting your Question in the 2 stoke tech fourm!
i was actually dabating that but i had a brain fart........so here it is...lol

 

[bada450r]

QUOTE (sleeperb @ Jun 18 2008, 04:34 PM) index.php?act=findpost&pid=3109The 4mill Mini I built had the same jetting in it my buddies 16mm Cheetah had and ran like a champ. So I'm gonna say it will need more fuel.
my 10 mil runed really hard with the initial jetting set up i had which was based on my cheetha but as i tuned the bike and jetted down it stated to wake up little by little.......but you know alky you get no color on the plugs only after the 8th pass or some [censored], which i didnt get to make cuz my second gear broke........i really dont want this motor to be on the very edge,so i ended up getting some smaller needles this week so hopefully that will do the trick

 

[[email protected]]

thats a nice set up. wish i had went with a 10 on mine. what intake/exhaust set up are you running on you twister

 

[Kawiking]

you get it figured out, pablo ?