ATV Drag Racer Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
623 Posts
Discussion Starter · #1 ·
I have custom reed cages built by my engine builder currently. The problem is i am putting NOS on the quad and it has carbon fiber reeds so they wont work. Next problem is i was going to swap the reed spacer front in front of the reed and put the NOS nozzle there and have epoxy reeds made but the reed cage is to large to fit without the spacer in front of it. My cables aren't long enough to put a spacer in front and back so i'm just kinda screwed.

4MILL full drag port on alky

Whats the best reed cage ? Any1 make special billet ones etc?
 

·
Registered
Joined
·
623 Posts
Discussion Starter · #5 ·
Into the front of the carbs? Just kinda would rather not weld on them. Might end up having to not having any luck finding any reeds or cages. SRP are out of stock for atleast another month and chariot isnt making anymore for 3 months. And TDR wont answer the damn phone.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top